CMC V series vertical shaft impactors (VSI) own the following advantages:
1.Especially suitable for the fine material (ψ 9mm below) which can not be processed by cone crusher.
2.Special discharge port design can handle fine material with high percentage of mud and moistures.
3.Unique high strength tungsten alloy rotor tips developed by CMC increase service life time up to 150-430ghrs, which is not beatable by usual manganese or tungsten.
4.Special multi type anvils design with changeable crushing angle reaches higher crushing efficiency.
5.Single motor drive design for reliable and efficient operation.
6.Fully open upper cover design for safe and rapid maintenance.
7.Precise weight balance for stable operation with minimum vibration and fast installation. It decrease dramatically foundation cost.
8.Total new design rotor with rapid and easy change of wear parts. Also the wear cost is low.
9.Unique crushing principle for low noise during operation which saves lots of anti-noise facility cost.
10.High cubic class product with minimum flakiness ratio.
11.Grease lubrication and no cooling system required.
In order to meet various different requirements and environments, CMC V series vertical shaft impactors (VSI) can be adjusted rotor speed, multiple cascade feed ratio, hydraulic feed control gate and multi-types anvils to get best condition and gain best product quality, maximum capacity and minimum wear cost.
V series Vertical Shaft Impactor
CMC V series vertical shaft impactors (VSI), with perfect combinations of multi types anvils which form various crushing angles, changeable rotor speed, multi-crushing action by cascade feed ratio and hydraulic adjustable feed control gate, provides higher capacity and better product quality of fine material crushing. Thus the applications are wide, no matter aggregate shaping, crushed sand, minerals fine crushing and waste recycling and can reach uncompetitive effectiveness.
The purpose of Slider Kit is to gather common slideshow-like jQuery functionalities (such as news sliders, photos galleries/sliders, carousels, tabs menus)
When tracking mouse movement, you usually need to know the actual position of the mouse pointer. The event object that is passed to the handler contains some information about the mouse coordinates.